![polaris digital wrench diagnostic software polaris digital wrench diagnostic software](http://docplayer.net/docs-images/69/61461397/images/37-0.jpg)
- Polaris digital wrench diagnostic software full activated#
- Polaris digital wrench diagnostic software install#
- Polaris digital wrench diagnostic software software#
Reference the Posi Lock Connector information in this chapter.ĭisconnect the wiring harness, then remove the tank from the snowmobile. Place in a well-ventilated area.įUEL FILTER (ARROWS POINTS TO THROTTLE BODY)Ģ006 models do not feature the drop-in style fuel pump. Polaris Digital Wrench Software JSocket Wrench v.0.5 The JSocket Wrench is a JDK 5.0 library (with a thin JNI layer) that provides support for low-level internet protocols in the Java programming language through subclasses of.
Polaris digital wrench diagnostic software install#
The package has a software package that you could install on whether pc or perhaps a laptop, and also the package also has a Victory Interface Adapter Cable and SmartLink Module and Cable Package. com Enter the code from Digital Wrench into the. Digital Wrench This interface then transfers diagnostic information for your computer, including DTCs and system statistics. Remove the fuel supply and return hoses from the top of the tank. The Polaris options VIN decoder is a great tool that you can use for checking. Remove the fasteners securing the fuel tank to the tunnel. Remove the console and the seat assembly.ĭisconnect the positive (+) battery cable from the battery.
![polaris digital wrench diagnostic software polaris digital wrench diagnostic software](https://m.media-amazon.com/images/I/61veAM1SiPL._AC_SL1500_.jpg)
Siphon the fuel out of the fuel tank into a suitable container. NOTE: Align pump flange so that the arrow is between the two alignment lines. Switch connector will initiate the START command and engage the starter motor. Pulling up on the safety slap switch when the jumper is installed on the ignition NOTE: The ECU will remained powered as long as the jumper is installed. When finished, always remember to remove the jumper, and reconnect the ignition switch connector! To bypass the shut down mode, install the ignition switch jumper tool, PN PS-48463Ĭarefully remove the ignition switch harness connector from the switch. After two minutes, the key will have to turned to the “START” position momentarily to re- establish communication and re-fresh the data stream. NOTE: The ECU will remain active for approximately two minutes when the diagnostic cable is connected to the system. Communications between the ECU and software should initiate. Turn the ignition key to the “START” position and release. Verify that the correct snowmobile has been picked (Model year as well as FS or FST) using the “CHOOSE VEHICLE” button. Start the Digital Wrench diagnostic software program. The connector is located under the steering loop bracket in the engine compartment. When connected, the laptop or PC supplies power to the fuse panel.ĭigital Wrench Diagnostic Cable ConnectionĬonnect the communication cable, PN PU-47151, to the four-pin (WHITE) diagnostic connector. Laptop Panasonic CF-19 Core i5 with preinstalled software Polaris Digital Wrench. Diagnostic tool Polaris Digital Wrench 4.2 Multilink XP.
Polaris digital wrench diagnostic software full activated#
Software full activated and you can update anytime from online. The key switch must be turned to the “start” position with the safety slap switch down to re-fresh the ECU data information and to extend the diagnostic on-time mode. Diagnostic Software Polaris Digital Wrench 4.2 version 2021 preinstalled in laptop. The ECU will go into a diagnostic mode when the diagnostic software is connected to the system and stay awake for ten The connector is located underneath the console. The diagnostic connector allows a technician to connect the Digital Wrench diagnostic software to the ECU.